C-2.4 Adjusting The Steering Column; C-2.5 Adjusting The Rear View Mirrors; C-2.6 Switching On The Cab Lights - Genie GTH-3512 Operator's Manual

■ C-2.4 ADJUSTING THE STEERING COLUMN
Both steering column and dashboard can be set to a
different angle.
To adjust the steering wheel angle, unlock lever 1 and
pull or push the steering wheel to the required position,
then re-lock lever 1.
DANGER
Before driving the machine, ensure the steering
wheel is perfectly clamped.
Handler with telescopic boom GTH-3512
OPERATING INSTRUCTIONS
■ C-2.5
The machine is fitted with three rear view mirrors:
• The right rear view mirror is located on a special
supporting bracket in advanced position and allows
checking the area behind the machine, on the right-
hand side. To adjust its position, manually rotate
the joint it is fitted with.
• The left rear view mirror is placed on the left upper
post of the windscreen and allows checking the
area behind the machine, on the left-hand side. To
adjust its position, manually rotate the joint it is
fitted with.
• The rear mirror is fitted on a special supporting
bracket, placed on the rear upper part of the frame.
It allows checking the area at the back of the
machine. To adjust its position, manually rotate the
joint it is fitted with.
■ C-2.6
The ceiling light fixture is fixed to the rear top strut of
the cab. The relevant lamp is switched on/off by switch
A.
C - 5
Page
Document 57.0008.7200 - 05/2007
ADJUSTING THE REAR VIEW MIRRORS
SWITCHING ON THE CAB LIGHTS
Courtesy of Crane.Market