D-3.3 Greasing - Genie GTH-3512 Operator's Manual

D-3.3 GREASING
■
ATTENTION
Before injecting grease into the greasers, thoroughly
clean them to avoid mud, dust or other matters that
mix with the lubricant and reduce or annihilate the
lubrication effect.
Remove any old grease with a degreaser from the
telescopes before smearing them with new grease.
Regularly grease the machine to grant it efficient
condition and a long life.
By means of a pump, inject grease into the special
greasers.
As the fresh grease comes out, stop the operation.
The greasing points are shown in the following figures:
- the symbol represents the points to be greased
by a pump
- the symbol represents the points to be
greased by a brush.
Handler with telescopic boom GTH-3512
MAINTENANCE
Running-in ____________________________ None
Ordinary ____________________ Every
D - 7
Page
Document 57.0008.7200 - 05/2007
SERVICE INTERVAL
10
Courtesy of Crane.Market
hours