Originating-Rp - H3C S3600 Series Command Manual

Command Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510
last-hop-router-address: IP address of the last-hop router.
Description
Use the mtracert command to trace the transmission path of the packet sent by the
multicast source over the network.
Example
# Trace the packets sent by the multicast source at 3.3.3.3.
<H3C> mtracert 3.3.3.3

7.1.10 originating-rp

Syntax
originating-rp interface-type interface-number
undo originating-rp
View
MSDP view
Parameter
interface-type: Interface type
interface-number: Interface number
Description
Use the originating-rp command to allow MSDP peer to use the specified interface IP
address as the RP address in the SA message when the MSDP peer creates SA
messages.
Use the undo originating-rp command to cancel configuration.
By default, the RP address in an SA message is the RP address configured by PIM.
Example
# Configure the IP address of Vlan-interface100 as the RP address of the created SA
message.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] msdp
[H3C-msdp] originating-rp Vlan-interface 100
Chapter 7 MSDP Configuration Commands
7-10