Peer Minimum-Ttl - H3C S3600 Series Command Manual

Command Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510
Description
Use the peer mesh-group command to add an MSDP peer to a mesh group.
Use the undo peer mesh-group command to cancel the configuration.
By default, an MSDP peer does not belong to any mesh group.
Example
# Configure the MSDP peer whose address is 125.10.7.6 as a member of the mesh
group Grp1.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] msdp
[H3C-msdp] peer 125.10.7.6 mesh-group Grp1

7.1.13 peer minimum-ttl

Syntax
peer peer-address minimum-ttl ttl-value
undo peer peer-address minimum-ttl
View
MSDP view
Parameter
peer-address: IP address of the MSDP peer to which the TTL threshold applies.
ttl-value: TTL threshold, ranging from 0 to 255.
Description
Use the peer minimum-ttl command to configure the minimum TTL value of the
multicast data packets encapsulated in SA messages and to be sent to the specified
MSDP peer.
Use the undo peerminimum-ttl command to restore the default TTL threshold.
By default, the value of TTL threshold is 0.
Related command: peer.
Example
# Set the TTL threshold to 10 so that only those multicast data packets with a TTL value
greater than or equal to 10 can be forwarded to the MSDP peer 110.10.10.1.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] msdp
Chapter 7 MSDP Configuration Commands
7-12