H3C S3600 Series Command Manual page 68

Command Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510
Parameter
all: Specifies all PIM neighbors.
group-address: Group address.
mask group-mask: Specifies a group address mask.
mask-length group-mask-length: Specifies the length of group address mask.
source-address: Source address.
mask source-mask: Specifies the source address mask.
mask-length source-mask-length: Specifies the length of source address mask.
incoming-interface: Specifies the incoming interface for the route entry in PIM routing
table.
interface-type interface-number: VLAN interface.
Description
Use the reset pim routing-table command to clear all PIM route entries or the
specified PIM route entry.
You can type in a source address before a group address in the command, as long as
they are valid. An error message will be given if you type in an invalid address.
In this command, if the group-address is 224.0.0.0/24 and source-address is the RP
address (where group address can have a mask, but the resulted IP address must be
224.0.0.0, and source address has no mask), then it means only the (*, *, RP) entry will
be cleared.
In this command, if the group-address is a group address, and source-address is 0
(where group address can have a mask and source address has no mask), then only
the (*, G) entry will be cleared.
This command shall clear not only multicast route entries from PIM routing table, but
also the corresponding route entries and forward entries in the multicast core routing
table and MFC.
Related command: reset multicast routing-table, reset multicast forwarding-table,
display pim routing-table.
Example
# Clear the route entries with group address 225.5.4.3 from the PIM routing table.
<H3C> reset pim routing-table 225.5.4.3
Chapter 6 PIM Configuration Commands
6-18