Pim Dm - H3C S3600 Series Command Manual

Command Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510
Use the undo pim bsr-boundary command to remove the configured PIM domain
boundary.
By default, no PIM domain boundary is configured on the switch.
After you use this command to set a PIM domain boundary on a VLAN interface, no
Bootstrap message can cross this domain boundary. However, the other PIM packets
can pass this domain boundary. In this way, you can divide the PIM-SM-running
network into multiple domains, each of which uses a different Bootstrap router.
Note that you cannot use this command to set up a multicast boundary. Instead, this
command configures just a PIM Bootstrap packet boundary.
Related command: c-bsr.
Example
# Configure domain boundary on VLAN-interface10.
<H3C>system-view
System View: return to User View with Ctrl+Z.
[H3C] multicast routing-enable
[H3C] pim
[H3C-pim] quit
[H3C] interface Vlan-interface 10
[H3C-Vlan-interface10] pim bsr-boundary

6.1.12 pim dm

Syntax
pim dm
undo pim dm
View
VLAN interface view
Parameter
None
Description
Use the pim dm command to enable PIM-DM.
Use the undo pim dm command to disable PIM-DM.
By default, PIM-DM is disabled.
Before enabling PIM-DM, make sure you enable multicast routing protocol by using the
multicast routing-enable command in system view.
Chapter 6 PIM Configuration Commands
6-12