Command Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510
View
System view
Parameter
None
Description
Use the msdp command to enable MSDP and enter MSDP view.
Use the undo msdp command to clear all configurations in MSDP view, release
resources occupied by MSDP, and restore the initial state.
Related command: peer.
Example
# Clear all configurations in MSDP view.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] undo msdp
7.1.8 msdp-tracert
Syntax
msdp-tracert source-address group-address rp-address [ max-hops max-hops ]
[ next-hop-info | sa-info | peer-info ]* [ skip-hops skip-hops ]
View
Any view
Parameter
source-address: Multicast source address
group-address: Multicast group address
rp-address: IP address of an RP
max-hops: Maximum number of hops to be traced, ranging from 1 to 255.The default
value is 16.
next-hop-info: Collects the next hop information.
sa-info: Collects the SA entity information.
peer-info: Collects the MSDP peer information.
skip-hops: Number of hops to be skipped before the detailed information is collected, in
the range of 0 to 255.
Chapter 7 MSDP Configuration Commands
7-7