Table of Contents
Advertisement
Snapshot Operations
Snapshot Operations in the Numeric Keypad Section
You can use the numeric keypad section for saving and recalling snapshots.
Saving a snapshot
To save a snapshot using the numeric keypad section, use the following
procedure.
Note
If you specify the number of a register which already holds a snapshot, then
the saving operation overwrites the previous snapshot. Before specifying the
number of the register in which you wish to save the snapshot, check that the
register is empty, or contains a snapshot which is no longer needed. You can
check the contents of registers using the REGISTER menu (see page 9-3).
1
2
3
4
7-6
Chapter 7 Snapshots
Set up the switcher in the state you wish to save in the snapshot.
In the numeric keypad section, press the SNAPSHOT button.
This delegates the numeric keypad section to snapshot operations.
Select the sub-register or sub-registers. You can press any combination
of the sub-register selection buttons, turning them on, as follows.
M/E1, M/E2 button: Select sub-registers M/E-1, and M/E-2,
respectively.
P/P DSK button: Select the PGM/PST sub-register.
USER button: Select the currently selected sub-registers of the USER
group (Frame Mem 1 and 2, AUX Buses, and CCR).
You can specify which of the sub-registers of the USER group this
button selects, using the REGISTER menu (see page 9-16).
Pressing the ALL button selects all sub-registers, and lights the other
buttons.
Press the STORE/LEARN button, turning it on.
The display shows the number of the register for which you carried out a
snapshot saving operation last time.
Advertisement
Table of Contents
