Table of Contents
Advertisement
Setup Relating to Interfaces With Peripheral Devices
(PERIPH Menu)
Carrying out setup relating to the interface to a routing switcher
(ROUTER INTERFACE menu)
14-42
Chapter 14 Setup
When the output of a routing switcher is input to the switcher, you can set the
correspondence in a menu. In this way, for example, the signal names
assigned on the routing switcher can be displayed on the control panel.
To set the correspondence between the routing switcher output and the
switcher input, use the following procedure.
1
In the PERIPH menu, press F6 (ROUTER IF).
The ROUTER INTERFACE menu appears.
SWER
INPUT
#2
F1
F2
F3
Function key indications in the ROUTER INTERFACE menu
2
Press F1 (SWER INPUT), or turn control knob 2 to select the switcher
button number.
3
Press F9 (DEST SELECT), or turn control knob 3 to align the cursor
with the name of the routing switcher bus (DESTINATION).
4
Press F7 (SELECT).
This confirms the correspondence between the routing switcher output
and the switcher input.
To end the connection, press F4 (NO CONNECT).
5
To inhibit cross-point switching by the routing switcher when recalling a
snapshot, press F10 (SS DISABLE), turning it on.
NO
CONNECT
F4
F5
F6
DEST
SELECT
SELECT
DISABLE
#3
F7
F8
F9
F10
SS
OFF
Advertisement
Table of Contents
