Table of Contents
Advertisement
Setup Relating to Interfaces With Peripheral Devices
(PERIPH Menu)
14-46
Chapter 14 Setup
To carry out these settings, use the following procedure.
1
In the PERIPH menu, press F8(GPI OUTPUT).
The GPI OUTPUT menu appears.
PORT
TRIGGER
SELECT
TYPE
#2
F1
F2
F3
Function key indications in the GPI OUTPUT menu
2
Press F2 (PORT SELECT) or turn control knob 2 to move the cursor and
select the required GPI output port.
3
Press F3 (TRIGGER TYPE), and select the trigger polarity.
Pressing F3 cycles the setting through
If you selected TALLY, continue to step 5.
4
Press F4 (PULSE WIDTH), then turn control knob 4 to adjust the output
pulse width.
5
Press F8 (ACTION SELECT) or turn control knob 3 to move the cursor
and select the action causing the GPI output.
6
Press F6 (SELECT) to confirm the selection of the action causing the
GPI output.
The action you have selected appears in the row for the output port
selected in step 2.
7
To make settings for more than one GPI output port, repeat steps 2 to 6
for each GPI output port.
8
To test the operation of a trigger, Press F10 (TEST FIRE).
This outputs a trigger from the GPI output port selected in step 2.
PULSE
WIDTH
.
SELECT
F4
F5
F6
,
ACTION
TEST
FIRE
SELECT
#3
F7
F8
F9
F10
,
, NOP, and TALLY.
Advertisement
Table of Contents
