Table of Contents
Advertisement
Setting
Setting for the
FlexiPad snapshot
recall LAST X function
Setting for the fader
lever function
Setting for the LAST
X button in the
numeric keypad
section
Setting for
manipulating
snapshot attributes
with the Flexipad
Setting to give priority
to the effect snapshot
name display in the
REGISTER menu
Making settings relating to control panel operation, screen
saver and fade-to-black function (PANEL ENABLE menu)
You can use the PANEL ENABLE menu for the following settings.
• Setting the screen saver delay time: Select the delay time until the screen
saver comes into operation after the last control panel operation. The
settings are: OFF (no screen saver function), 1, 3, 5, or 10 minutes.
• Adjusting the brightness of the display: Adjust the source name display
and numeric keypad section display
• Selecting the control over each bank given to the control panel: Select
the control given to the control panel over each of the M/E and PGM/PST
banks individually.
INHBT: Control is disabled. The display functions of the particular bank
also do not operate.
DSBL: Control is disabled. The display functions of the particular bank,
however, do operate.
ENBL: Control is enabled. The display functions of the particular bank
also operate.
• Setting the fade-to-black function: Select whether to enable (ENBL) or
disable (DSBL) the fade-to-black function.
Operation
Press F6 (FLX PAD SS LASTX).
This toggles the setting between ENBL and DSBL.
Press F7 (FADER CURVE).
This toggles the setting between MODE1 and MODE2.
Press F9 (KEY PAD LAST X).
This toggles the setting between ENBL and DSBL.
Press F10 (MORE), then press F1 (FIX PAD ATRIB
MODE).
This toggles the setting between MODE1 and MODE2.
Press F10 (MODE), then press F2 (REGS MENU
MODE). Pressing the button toggles the setting between
MODE1 and MODE2.
14-65
Chapter 14 Setup
Advertisement
Table of Contents
