Table of Contents
Advertisement
Specifying Sub-Registers and Edit Points
Selecting the sub-register to which editing applies
To select the sub-register (or channel) to which key frame editing applies,
press one of the sub-register selection buttons (M/E1, M/E2, P/P DSK,
USER, DME 1 to DME 4, and DME GLBL).
Specifying edit points
To insert, modify, or delete a key frame, it is necessary to stop the effect at
the appropriate point on the time axis. This is referred to as an edit point.
It is possible to carry out editing at any key frame in the effect, or between
two key frames.
To specify an edit point, carry out the following operation on the key frame
control section.
For details of the component parts of the key frame control section, see page
2-29.
1
Press the EDIT ENBL button, turning it on.
2
Carry out any of the following operations.
• Move the fader lever and stop the effect at the desired point.
• Press the NEXT KF button to specify the next key frame after the
current position.
• Press the PREV KF button to specify the last key frame before the
current position.
• To move to a specified key frame, press the GO TO KF button, and
enter the number of the key frame from the numeric keypad.
• To move to a specified time code position, press the GO TO TC button,
and enter the time code value from the numeric keypad.
Chapter 8 Key Frame Effects
8-7
Advertisement
Table of Contents
