Table of Contents
Advertisement
Setup Relating to Operations From the Control Panel
(OPERATION Menu)
14-64
Chapter 14 Setup
Setting
Setting the function of
the ALL button in the
numeric keypad
section
3
Press F7 (CUSTOM MODE).
The CUSTOM MODE menu appears.
4
Carry out the operation shown in the following table corresponding to the
desired setting.
Setting
Setting the operating
mode for the FlexiPad
Setting the linkage
between the transition
type selection buttons
and the FlexiPad
Setting the method of
reference channel
selection using the
numeric keypad
section
Setting the linkage
between snapshot
recall from the
numeric keypad
section and the
FlexiPad
Making the settings
relating to the lighting
of buttons when the
same signal is
assigned to more than
one cross-point button
Operation
Carry out the following procedure.
1 Press F8 (PROGRAM BUTTON).
The PROGRAMMABLE BUTTON menu appears.
2 Press F10 (DEFINE ALL).
The ALL BUTTON DEFINE menu appears.
3 Press F1 (SELECT) and align the cursor with the block
that contains the desired button.
Depending on the selected block, the button names that
can be assigned to other function keys than F1 appear.
4 Press the function keys as required to highlight the
function key indications for the required functions while
not highlighting the function key indications for the
functions not required.
Operation
Press F1 (FLX PAD MODE).
This cycles the setting through MODE1, MODE2, and
MODE3.
Press F2 (FLX PAD AUTO SELECT).
This toggles between MODE1 and MODE2.
Press F3 (REF SEL MODE).
This toggles between MODE1 and MODE2.
Press F4 (SS RECALL MODE).
This toggles between MODE1 and MODE2.
Press F5 (XPT TALLY).
This toggles the setting between MODE1 and MODE2.
Advertisement
Table of Contents
