Table of Contents
Advertisement
Basic Frame Memory Operations
Preparations
Assigning the output signal to a cross-point button
Before you can see the output of frame memory on a monitor, for example, it
is necessary to assign the output signals of frame memory 1 and frame
memory 2 (FM1 and FM2) to cross-point button.
This assignment is carried out from a SETUP menu (see page 14-53).
Selecting the output signal from the operating block
In the M/E-1, M/E-2 or PGM/PST bank, press the cross-point button
allocated to the output signal from the frame memory.
This allows you to check the output video from the frame memory on a
monitor, for example.
The following description assumes that the above two preparatory steps have
been taken.
Using the frame memory menu, it is possible to select whether the signal
output from the frame memory is the stored frame in memory (MEM) or the
input video signal about to be written to the frame memory (IN). This setting
is described in the procedure below.
Chapter 6 Frame Memory
6-5
Advertisement
Table of Contents
