Table of Contents
Advertisement
2
Select the cross-point button to which you wish to assign an input signal,
using either of the following methods.
• Hold down F1 (BUTTON No.) and press the required cross-point
button in the auxiliary bus bank.
• Hold down F1 (BUTTON No.) and use the cursor movement keys to
select the required cross-point button.
• Hold down F1 (BUTTON No.) and turn control knob 2.
• Hold down F1 (BUTTON No.) and use the numeric keypad to enter the
required cross-point number.
The indication of the button you have pressed switches to reverse video.
3
Press F8 (SOURCE SELECT) or turn control knob 3 to move the cursor
and select the required input signal.
If you do not want to assign VIDEO SOURCE, press F2 (INHIBIT), and
if you do not want to assign KEY SOURCE, press F5 (INHIBIT).
4
To confirm the VIDEO SOURCE assignment, press F3 (SELECT), and
to confirm the KEY SOURCE assignment, press F6 (SELECT).
Proceed to step 5 and following steps if you wish to assign a name to the
selected input signal.
5
Press F10 (SOURCE NAME).
The SOURCE NAME menu appears.
SOURCE
SELECT
#2
F1
F2
F3
Function key indications in the SOURCE NAME menu
6
Press F2 (SOURCE SELECT) or turn control knob 2 to move the cursor
and select the signal to which you wish to assign a name.
SELECT
F4
F5
F6
F7
USER
SET
NAME
NAME
USER
SELECT
SELECT
NAME
#3
#4
F8
F9
F10
(Continued)
14-55
Chapter 14 Setup
Advertisement
Table of Contents
