Idling Detection (Message Via Digital Output – Function Code 20) - EURA DRIVES E800 series Safety Instructions, Installation And Operating Manual

Analogue signal interruption detection (message via digital output – function code 18)
F741
Analogue signal
interruption – fault
handling mode
F742
Threshold for
detection (%)
If F400 / F406 set lower than 0.01V interruption detection is deactivated (a minimal value of 1V is recommended)
Detection threshold is referred to lower limits for analogue input signals, set in parameters F400 / F406
Heatsink over-temperature warning (message via digital output – function code 16)
F745
Warning threshold (%)
F747
Temperature depending carrier frequency
adaption
All referred to 95°C, the inverter trip temperature
With temperature depending PWM frequency-adaption activated (F747=1), inverter will start to decrease PWM frequency
gradually, at heatsink temperature of 86°C
If PWM frequency is configured for "RANDOM" (F159=1), temperature depending PWM adaption is always deactivated
Idling detection (message via digital output – function code 20)
F754
Idling current threshold (%)
F755
Delay time for idling detection (sec.)
E800 – Rev.01 -EN- SOFT Rev. 2.04
© 2015 EURADRIVES EUROPE GmbH
14) Parameter group 700: Error handling and protection functions
Selection 0: deactivated
1: STOP and AErr
2: STOP without any message on display
3: Inverter continue running with f-min
4: Reserved
Range: 1...100 %
Range: 0...100%
Selection: 0: deactivated
Range: 0...200 %
Range: 0...60 sec.
on display
1: activated
- 58 -
Default setting: 0
Default setting: 50%
Default setting: 80
Default setting: 1
Default setting: 5%
Default setting: 0.5 sec.