Table of Contents
Advertisement
7) Parametrization
For easier prarametrization, the parameter set is divides into 11 parameter groups:
Parameter type
BASIC parameters
Inverter control, set-point origin setup
Function assignation to digital I/Os - diagnosis
Analogue I/O signal configuration
Fixed-frequency control, cycle control
DC-Brake, limiting functions, auxiliary functions
Fault handling – configuration of protection function
Motorparameter, AUTOTUNING
Serial link parameter set
PID controller parameter, pump control functions
Selection of parameters, modification and saving:
The
key toggles between all different values on the display.
F
prefix indicates parameter level and the number refers to a configuring parameter.
Once on parameter level, the
key toggles between single and multi parameter step. If
selected, if off, group mode is selected, and
key selects the parameter on the display, and the parameter value is shown. The blinking
digit may be changed, using
digits). Pressing
Parameter types:
Read only parameters: These parameters can not be changed, the tentative to modify will end up in Err1 message – read-only
GRAY
parameters are listed in
Dynamic parameters: These parameters are allowed to modify with inverter in START and in STOP mode, listed in red bold
characters on this description:
Static parameters: To modify with inverter in STOP mode only, otherwise, Err1 is displayed, static parameters are listed in red,
Fxxx
italic bold characters as
E800 – Rev.01 –EN-SOFT Rev. 2.04
© 2015 EURADRIVES EUROPE GmbH
7) Parametrization
keys are used to flip through parameters.
keys (eventually use
again memorizes the modified parameter value.
characters
Fxxx
Parameter Nr. Range
F100 - F160
F200 - F230
F300 - F330
F400 - F473
F500 - F572
F600 - F623
F700 - F740
F800 - F830
F900 - F930
FA00 - FA30
is on, single mode is
keys moves in steps of 100.
key to switch through single
- 31 -
Gruppe
100
200
300
400
500
600
700
800
900
A00
Hide quick links:
Advertisement
Table of Contents
