Operating Panel; 7-Segment Display:; Status Led; Keys And Functions - EURA DRIVES E800 series Safety Instructions, Installation And Operating Manual

6) Operating panel

Inverter control, parametrization, operating-parameter display and
inverter-status information are all done through the operation
panel. This consists in seven segment, 4-digit display, six button
keypad field and 4-LED status line.
The adjacent picture shows the standard ve sion:
7-segment display, status LED and keypads
An optional build-in potentiometer is available

7-segment display:

The content of the display can be configured, to show different
operating parameters, while inverter in STOP or START mode,
error messages, parameters and parameter values (for
configuration see chapter: Parameter group 100 – BASIC parameter)
The key is used to cycle through all programmed
content, including configuration parameter level.
(Configuration parameter on display have always a leading
Faults are displayed with the respective error code.
Flashing numbers in STOP mode indicate the target-frequency,
which the inverter will reach after START command is given.

Status LED:

To display the inverter status:
Inverter in START mode.
The display shows the
programmed working
parameters

Keys and functions

Cycling through
different display START command
content
E800 – Rev.01 -EN-SOFT Rev. 2.04
© 2015 EURADRIVES EUROPE GmbH
6) Operating panel
r
To indicate the rotating
direction
STOP command
Toggle
switch for
ERROR RESET
- 29 -
F
).
Toggle with key
ON: single step modus is
selected for parameter
cycling
OFF:parameter group
cycling
Parameter:
Selection, and save
ON, if the value on the
display corresponds to
output frequency
Increment /
Decrement Key