Common; Specified Application Of Frequency Inverters; Observe Specific Standards And Rules - EURA DRIVES E800 series Safety Instructions, Installation And Operating Manual

1) Common installation rules and safety information regarding EURA E800 inverters

Common:

DANGER
DANGER

Specified application of frequency inverters

.
DANGER

Observe specific standards and rules

DANGER
E800 – Rev.01 -EN- SOFT Rev. 2.04
© 2015 EURADRIVES EUROPE GmbH
Frequency inverters operate with voltages, hazardous to
humans
Depending on inverters protection degree (IP class) and mounting
conditions, life parts may be accessible.
During heavy duty operation, and especially in case of malfunction,
parts/surfaces of inverters or accessory may reach dangerous
temperatures, which may result in personnel injury.
Inadmissible removal of covers or other parts of the inverter, improper
use, and not qualified mounting or operation may result in high risk for
personnel injury and/or machinery damage
All activity for mounting, cabling, placing into operation and operation
of the inverter must be done exclusively by proper educated and
trained people.
The standards IEC 364 and/or CENELEC HD384, DIN VDE 0100 and
all other national safety standards are to observe.
Trained people has specific professional training, knowledge of all
relevant standards and safety rules and experience in application of
electrical/electronic drive systems.
These professionals are in condition to judge assigned duties, and
resulting risks.
The inverters, reported in this manual are components of
electrical/electronic drive systems and determinate for integration in
machines and plants only.
The E800 serves exclusively for the control and regulation of three
phase motors (asynchronus / synchronus motors)
The connection of loads, other than above listed, may result in
damage of the machinery, destruction of the inverter or connected
equipment, and serious risk of personnel injury.
It is not allowed, to place in operation the plant, before the
compliance with all standards of the machinery safety regulation
(89/392/EWG) and the EMC rules (89/336/EWG) has been checked
Inverters are conformal with low voltage directive (73/231/EWG).
Harmonized standards EN50178 (VDE160) and EN60439-1
(VDE0660, T. 500) are applied.
EURA DRIVES E800 is a product with limited availability (in sense of
IEC 61800-3). Frequency inverters may create high frequency noise,
in case the operator is responsible for proper countermeasures.
- 2 -