Parameter Group 400: Analogue I/O Channel Configuration; Configuration Of Analogue Speed Reference Channels - EURA DRIVES E800 series Safety Instructions, Installation And Operating Manual

11) Parameter group 400: Analogue I/O channel configuration

11) Parameter group 400: Analogue I/O channel configuration
Two different control boards are used in E800 inverters, depending on inverter framesize:
Inverter power-range up to 22 kW – SIZE E1-E6
Inverter power-range from 30 - 90 kW – SIZE C3-C6
Both control boards offers independent analogue input/output channels. Each of them can be adapted to various
input/output signals – all configuration must be done by software/hardware setting
Details and instruction for hardware setting: see chapter 5) Control hardware and IO/ channel configuration
Following instruction describes, how to set software parameters

Configuration of analogue speed reference channels

keypad):
F400
Range definition AI1
F401
Assignation lower limit
F402
Range definition AI1
F403
Assignation upper limit
F404
Gain factor AI1
F405
AI1 Filter factor AI1
The speed range is defined by upper and lower limits, the area in between corresponds to 100%
(example: F400=2, F402=8, 2...8V correspond to 0....100%)
Parameter F401 and F403 are used to move the range limits (in %). Rules: 0 = -100%, 1 = 0%, 2 = +100%.
(example: F401=0, F403=2 then 100% signal (the range between upper and lower limit) correspond to -
100%...+100% reference). In this case 0...10V input signal corresponds to - 50 Hz...0Hz...+50 Hz).
Configuration examples:
Speed reference channel selected:
F-max:F111=50 Hz, F-min:F112=0Hz
All other: default set
Speed reference Output frequency
0..10V 0Hz...+50 Hz
0...10V -50Hz....0Hz...+50Hz
0...10V -50Hz....0Hz
0...10V 20Hz....50 Hz
0...20mA 0Hz....50Hz
4...20mA 0Hz....50Hz
E800 – Rev.01 -EN- SOFT Rev. 2.04
© 2015 EURADRIVES EUROPE GmbH
– lower limit (V) Range 0.00V...F402
AI1 Range: 0...F403
– upper limit (V) Range: F400...10.00V
AI1 Range: (1.00, F401)...2.00
Range: 0.0...10.0
Range: 0.1...10.0
A= (F401-1)*100%
B= (F403-1)*100%
C= F400
D= F402
AI1 - F203=1,
F400
0.00V
0.00V
0.00V
0.00V
0.00V
2.00V
- 47 -
AI1, AI2, AI3 (A3 = potentiometer on
B
A
C D
F401 F402 F403
1.00 10.00V 2.00
0.00 10.00V 2.00
0.00 10.00V 1.00
1.40 10.00V 2.00
1.00 10.00V 2.00
1.00 10.00V 2.00
Default setting: 0.00V
Default setting: 1.00
Default setting: 10.00V
Default setting: 2.00
Default setting: 1.0
Default setting: 0.10
AI1
F404 Hardware setting
1.0 0...10V
1.0 0...10V
1.0 0...10V
1.0 0...10V
1.0 0...20mA
1.0 0...20mA