Table of Contents
Advertisement
1) Common installation rules and safety information regarding EURA E800 inverters
Handling, transportation and storage
DANGER
Installation of the inverter
DANGER
E800 – Rev.01 -EN- SOFT Rev. 2.04
© 2015 EURADRIVES EUROPE GmbH
Inverter components may become damaged and insulating distances
may be reduced, as a result of improper transportation, handling or
storage of the drive.
In this case, the inverter does not anymore comply with product
specific standards and rules, and it is not allowed to place it into
operation.
Therefore it is mandatory, to check the inverter for mechanical
integrity, before installation and operation.
The inverter may contain components, sensitive to electrostatic
discharge. Therefore avoid, touch components inside the drive.
It is recommended to store the inverter, using the original box.
If inverters are stored or out of use for more then one year, DC
capacitors may lose their capacity. Please contact the inverter
manufacturer for reformatting procedure
Frequency inverters must be installed in a proper cabinet.
Only fixed installation is permitted.
Follow all effective standards and rules for correct grounding!!
All minimum distances to other inverters or equipment in the cabinet
are to respect. Minimum distances are reported later on this manual.
Allow adequate air circulating, especially, in case of vertical mounting,
one on top of the other.
Use proper shielded cables, for inverter control signals and feed back
signals
Intrusion of dust, liquids, water, steam and aggressive gases must be
excluded
Attention on adequate heat exchange of the cabinet
Use of the inverter in explosion risky area is not allowed
- 3 -
Hide quick links:
Advertisement
Table of Contents
