Inverter Mounting; Mounting In Cabinet; Maintenance And Service - EURA DRIVES E800 series Safety Instructions, Installation And Operating Manual

3) Inverter mounting

Please read all, what reported on chapter 1) Common installation- and safety rules for EURA DRIVES inverters, series
E800 before proceeding with inverter mounting, cabinet wiring, and putting the system into service.

Mounting in cabinet

Accordingly to the protection degree class (IP20/21), the inverter must be placed in a proper cabinet.
The inverter should be mounted vertically, using all available mounting holes.
Avoid mounting of more inverters in vertical array. If absolutely necessary, keep double mounting distances
The table below, shows the minimum mounting distances in vertical and horizontal direction
Sufficient heat exchange of the cabinet must be guaranteed, to keep all operating conditions within the specified limits.
Framesize Mounting
A≥150mm
＜30kw
≥30kw A≥200mm
Fans:
All inverters out of the E800 series are forced ventilated. Specific parameters are used to set various fan
operating modes: Allways ON (F702=2), ON with inverter in running mode (F702=1), or temperature controlled (F702=0)
(F703=Temp. threshold)
see 14) Parameter group 700: Error handling and protection functions (F702-F703)

Maintenance and service:

Provided that the inverter is working in respect of specified environmental conditions, provided that the inverter is
used for proper application, and all instructions have been exactly followed for installation, putting in service and
operation, the inverter does not need any specific maintenance.
E800 – Rev.01 -EN- SOFT Rev. 2.04
© 2015 EURADRIVES EUROPE GmbH
3) Inverter mounting
B≥50mm
B≥75mm
Distances for mounting in
- 15 -
A
B
B
A
cabinet