Two / Three Wire Control For Start – Stop - Rotation - EURA DRIVES E800 series Safety Instructions, Installation And Operating Manual

Two / Three wire control for START – STOP - Rotation:
This control mode overwrites the setting in F200, F201, F202
F208
Activation special
Two / Three wire control
F208=0: If Fixed-frequency control is required this mode must be deactivated!
If F208>0: functions F200, F201 and F202 are ignored.
"FWD", "REV" and "X" are digital terminal input signals for two / three wire control mode. This logical signals are assigned to
OP1.....OP6 (OP8) through parameters F316....F323
Assigning-code for OPxx: FWD=15, REV=16,
F208=1:
Two wire Type 1
K1=START forward (default on OP3)
K2=START reverse (default on OP4)
F208=2:
Type 2
Two wire
K1=START
(default on OP3)
K2=Rotating direction (default on OP4)
F208=3:
Three wire Typ 1
Pulse/pushbutton control:
FWD(SB2)=START-impulse
forward
FWD=NO
REV(SB1)=START-impulse
reverse
REW=NO
X(SB3)=cancel impulse (STOP)
X=NC
F208=5:
Three wire Typ 3
Pulse/pushbutton control:
FWD (SB1) Impulse: START-forward / STOP
Toggle function
FWD=NO
REV (SB2) Impulse: START-reverse / STOP
Toggle function
REV=NO
E800 – Rev.01 -EN- SOFT Rev. 2.04
© 2015 EURADRIVES EUROPE GmbH
9) Parameter group 200: Inverter control
Selection:
0: Deactivated
1: Two-wire, Type 1 (static)
2: Two-wire, Type 2 (static)
3: Three wire, Typ1 (Impulse / pushbutton control – dynamic)
4: Three wire, Typ2 (Impulse / pushbutton control – dynamic)
5: Pulse / pushbutton control (dynamic)
X=17 – see chapter: Parameter group 300 – Digital I/O configuration
K1
FWD
REV
K2
CM
K1
FWD
REV
K 2
CM
SB2
FWD
SB3
X
SB1
REV
CM
SB1
SB2
- 41 -
Truth table
K1
0
1
0
1
Truth table
K1
0
0
1
1
F208=4:
Three wire Typ 2
Pulse/pushbutton control:
FWD(SB1)=START-impulse
FWD=NO
X(SB2)=cancel-impulse (STOP)
X=NC
K1=Direction
FWD
FWD
REV
REV
CM
Default
setting: 0
K2
0 Stop
0 forward
1 reverse
1 Stop
K2
0 Stop
1 Stop
0 forward
1 reverse
SB1
FWD
SB2
X
K1
REV
CM