Renesas R-IN32M3 Series User Manual page 76

R-IN32M3 Series: Board design edition
REVISION HISTORY R-IN32M3 Series User's Manual (Board design edition)
Rev. Date
1.00 Jul 26, 2013
1.01 Dec 02, 2013
2.00 Dec 26, 2013
2.01 Feb 07, 2014
2.02 May 30, 2014
2.03 Sep 30, 2014
2.04 Dec 25, 2014
3.00 Feb. 28, 2017
R18UZ0021EJ0400
Dec. 28, 2018
Page
- First edition issued
10,12 Add the TEST pin processing
22 Add " 9. Notes of CC-Link IE FIeld user (only R-IN32M3-CL)"
11 Add a description of 6. GPIO port pins
20 Add a description of 8.GMII pins
23 Modify a description of 10. Notes of CC-Link IE Field use
24 Add a description of "11. External MPU/memory interface pins"
33 Add a description of "12. Serial Flash ROM memory connection pins"
34 Add a description of "13. Asynchronous Serial Interface J(UARTJ) connection pins"
35 Add a description of "14. I
36 Add a description of "15. EtherCAT EEPROM I
37 Add a description of "17. CAN pins"
38 Add a description of "17.JTAG/trace pins"
24 Modify the mode description of the case of MEMCSEL=High and HIFSYNC=Low.
25,26 Delete HBCYSTZ pin connection of "Fig 11.1" and "Fig 11.2"
Modifiy the width of data bus of "Fig 11.2"
Add the description of Note4-6 of "Fig 11.1" and "Fig 11.2"
27,28 Delete HBCYSTZ pin connection of "Fig 11.3" and "Fig 11.4"
Modifiy the width of data bus of "Fig 11.4"
Modifiy the width of address bus of "Fig 11.4"
Add the description of Note4-6 of "Fig 11.3", "Fig 11.4"
29, 30 Separete and add the description about "synchronous SRAM type transmission
mode"
2 Add a notes of "2.1 Power-on-off sequence"
1-9 Modify Eglish expression about capter 1-4
11 Modify part name of inductor VLC5028T to VLCF5028T in "5.1Built-in regulator
used"
Modify ESR value of condenser 300 ohm to 300 mohm in "5.1Built-in regulator
used"
25-29 Fig.11.1-11.6 Modify signal name BUSCLK to HBUSCLK
40 Add a description in "17.JTAG/trace pins"
22, 23 Add Fig. 9.1 in 9.CC-Link pins
29, 30 Modify Fig.11.5, 11.6 to add HBCYSTZ connection, modify Adress bus number,
and delete HHPGCSZ connection. And modify Note2, 4, 5 description in 11.1.3
Synchronous SRAM type transmission mode
1 "1.1 Definition of Pin Handling and Symbols in This Manual" was newly added.
7 3.3 Oscillation Circuit Configuration Example
Pin handling and the GND description in Figure 3.2 were modified.
Caution on a resonator was modified.
8 4.1 Recommended Configuration of Filter
Pin handling and the GND description in Figure 4.1 were modified.
Description
Summary
2
C connection pins"
2
C connection pins"
Revision History
C - 1