Installation - NEC Express5800/R120g-2M User Manual

Chapter 2 Preparations
1.11.5

Installation

Follow the steps below to install a DIMM.
1. See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2. Open levers on left and right sides of
DIMM slot, and remove the dummy cover.
3. Push the DIMM straight into the slot.
When a DIMM is inserted into the slot, the
lever automatically closes.
4. Continue to install or remove internal optional devices, mount and connect the server, and turn on the
server.
5. Confirm that no error messages are displayed in POST screen.
If any error messages are displayed, see Chapter 3 (1. POST Error Message) in "Maintenance Guide".
6. Run BIOS Setup Utility, and select Advanced  Memory Configuration  Memory Information.
Make sure the capacity of added DIMM is displayed properly.
See Chapter 2 (1. System BIOS) in "Maintenance Guide".
7. Select Advanced  Memory Configuration  Memory Retest, and set Yes.
8. Select Server  Power Measurement Policy, set One Time, and then select Save Changes and Exit.
9. Set the size of Paging File to the recommended size (1.5x total memory size) or more.
If using a Windows OS, see Chapter 1 (6.1 Specifying Memory Dump Settings (Debug Information)) in
"Installation Guide (Windows)".
For other OS, follow the manual of the OS.
Note
Keep the removed dummy cover for future use.
Important  Make sure the orientation of the DIMM. The DIMM has a notch, preventing
being incorrectly inserted.
 Do not apply too much pressure when you push a DIMM into the slot.
Doing so can damage the socket or terminal part.
Express5800/R120g-2M User's Guide
1. Installing Internal Optional Devices
Notch
Key
59