NEC Express5800/R120g-2M User Manual page 85

Chapter 2 Preparations
PCIe slot 1D (Low profile)
PCIe slot 2D (Low profile)
PCIe slot 3D (Low profile)
PCIe slot 1D (N8116-46)
PCIe slot 2D (N8116-46)
PCIe slot 3D (N8116-46)

If an additional LAN card is installed, it is hard to push the catch of the connector with your finger that is
connected to the LAN card. Disconnect the connector pushing the catch with a standard screwdriver. At
this time, be very careful for the screwdriver not to damage the LAN card.

If a bootable device such as a PCI card or USB device is added, or boot mode is changed the boot order
may change. Check priority for the boot device in BIOS Setup Utility.
[Boot] - [CD/DVD Priorities] → Check the display
[Boot] - [Removable Priorities] → Check the display
[Boot] - [HDD Priorities] → Check the display
[Boot] - [ Network Priorities] → Check the display

If the boot device is an HDD and located under an optional RAID Controller, the display is (Bus xx Dev
00) PCI RAID Adapter. Note that the value for xx changes depending on the PCI slot where a RAID
Controller is installed.

For a RAID Controller, LAN card (network boot), or Fibre Channel controller, if a hard disk drive on which
an OS is installed is connected, set the option ROM for that slot to Enabled. See Chapter 2 (1. System
BIOS) in "Maintenance Guide" for how to specify it.
PCI device
Express5800/R120g-2M User's Guide
1. Installing Internal Optional Devices
Bus number Device number
40h 0
C0h 0
E0h 0
40h 0
62h 0
C0h 0
Function number
X
X
X
X
X
X
85