NEC Express5800/R120g-2M User Manual page 96

Chapter 2 Preparations
5. Attach the RAID Controller bracket to RAID
Controller with two screws you have removed
in Step 3.
6. Insert the RAID Controller slightly into the
dedicated slot while tilting the card.
7. Gently place the RAID Controller on bottom
plate of chassis so that it become horizontal
to the motherboard.
8. Insert the RAID Controller into the slot while
keeping horizontal state.
9. Secure the RAID Controller bracket with two screws you have removed in Step 4.
10. Disconnect SAS/SATA cable from SATA connector on motherboard.
 When four or less hard disk drives are installed:
Connect SAS/SATA cable removed in Step 8 to connector (Ports 0-3) on RAID Controller.
 When five or more hard disk drives are installed:
Connect SAS/SATA cable removed in Step 8 to connector (Ports 0-3) on RAID Controller.
Connect SAS/SATA cable provided with the server to connector (Ports 4-7) on RAID Controller.
Remove a single screw from server chassis, and remove battery tray for RAID Controller.
Connect another end of SAS/SATA cable that has been connected to connector (Ports 4-7) on RAID
Controller, to the connector on backplane.
11. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
(2)
When using optional RAID Controller (N8103-179)
See Chapter 2 (1.12.4 Installing FBU).
96
Express5800/R120g-2M User's Guide
1. Installing Internal Optional Devices