NEC Express5800/R120g-2M User Manual page 128

Chapter 2 Preparations
(2) Removal procedure
Remove the server from the rack in the following procedure.
1. Make sure that the server is turned off and then disconnect the power cord or all interface cables from
the server.
2. Remove the front bezel.
3. Slowly pull the server out while pressing the
buttons located on both sides of the front of
the server.
4. The server will come to a stop halfway.
Press and hold Rail Stoppers (blue) on the
rail and pull the server out of the rack.
5. Hold the server firmly and remove it from the rack.
128
Important
At least two persons are required to remove the server from rack.
Important
Be careful not to get your fingers caught in the rails or lever.
Important
 While more than one person is supporting the bottom part of the server,
slowly pull out the server.
 Do not apply pressure on the server from top when it is being pulled out.
Doing so cause the server to drop.
Express5800/R120g-2M User's Guide
2. Installation and Connection
Press the button
to unlock
レールストッパー Rail Stopper