Status Indicators; Power Led ( ); Status Led 1,2 ( ) - NEC Express5800/R120g-2M User Manual

Chapter 1 General Description
4.7

Status Indicators

4.7.1 POWER LED (
POWER LED indicates power ON/OFF status of the server.
POWER LED pattern
On (green)
Off

4.7.2 STATUS LED 1,2 ( )

While hardware is operating normally, STATUS LED 1 lights green. STATUS LED 2 is off. STATUS LED 1 is
off or STATUS LED 2 lights/flashes amber if there is a hardware failure.
If the LED indication does not change even if the action below is performed, contact your sales
representative.
STATUS LED pattern
STATUS LED 1 STATUS LED 2
On (green) Off
On (green) On (amber)
Blinking (green) Off
Off Off
)
The server is normally powered on.
The server is off-powered.
The server is in halt status.
Tips
If NEC ESMPRO is installed, you can view error logs to check the causes of
failures.
Description
The server is operating normally.
Initialization of BMC is in progress.
Memory is in a degraded state.
Operating while CPU error is detected.
In redundant power configuration, power is
not supplied to either of power unit.
The power is off.
POST is in progress.
Memory dump is being requested.
Note: It remains green if the dump is caused
by software.
CPU was not recognized.
Watchdog timer expired.
Express5800/R120g-2M User's Guide
4. Names and Functions of Parts
Description
Action

Wait until initialization of BMC completes. If
the status remains the same after several
minutes pass, contact
representative.
Check the electrical system such as power
cords. If there is no problem with the system,
contact your sales representative.
If the power is not on, Turn on the server. If
POST is in progress, wait until POST
completes. If DUMP switch is pressed, wait
until the memory dump is completed.
If a problem persists after taking these actions,
contact your sales representative.
your sales
31