NEC Express5800/R120g-2M User Manual page 82

Chapter 2 Preparations
7. Connect an interface cable and power cable that come with the backup device.
8. Connect the USB cable to the connector on motherboard.
9. Continue to install or remove internal optional devices, mount and connect the server, and power on the
server.
10. Make sure that no error messages are displayed on POST screen.
For details on POST error messages, refer to Chapter 3 (1. POST Error Message) in "Maintenance
Guide".
11. Install the driver for backup device.
1.15.2
Removal
Remove the backup device in reverse order of installation steps.
82
Power cable
Note
Use the power cable that extends to the expansion bay of the server.
Note
Make sure that the USB cable does not come in contact with electronic component on
motherboard.
Important
When N8151-125 Internal RDX (USB) is connected, the boot device priority may be
changed. On the Boot menu of BIOS SETUP, specify the boot priority of removable
device lower than that of boot device.
Express5800/R120g-2M User's Guide
1. Installing Internal Optional Devices
USB cable