NEC Express5800/R120g-2M User Manual page 136

Chapter 3 Setup
4. After a while, the following message is displayed on the screen. (The on-screen message depends on
your environment.)
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
By pressing the function key following messages, you can call the functions below upon completion of
POST.
<F2> key:
<F3> key:
<F4> key:
<F12> key: Boot from network.
5. When Legacy is specified for Boot Mode, a message that prompts you to start the utility is displayed
depending on the installed controller.
Example of RAID controller:
Press <Ctrl> <R> to Run MegaRAID Configuration Utility
The utility starts by pressing <Ctrl> + <R> keys.
For details on the utility, refer to the manual supplied with each optional board.
Depending on the configuration, the message "Press Any Key" might appear to prompt a key entry. This
is a behavior of the BIOS of the optional board. Continue to operate after checking the manual of the
optional board.
6. When Secure Boot is set to Enabled in Security menu and Invalid Signature Detection is set to Halt
in BIOS Setup Utility(SETUP), the message will be displayed saying that the invalid signature was
detected in the folloing cases:
・The boot image in a bootable device is unsigned.
・The signature of the Boot image in a bootable device is illegal.
In such cases, turn off the server and check that the signature of the boot image in a bootable device
is correct. Connect the device for which Secure Boot is enabled to the server and restart.
136
Run BIOS Setup Utility (SETUP). For information on the SETUP, see Chapter 2 (1. System
BIOS) in "Maintenance Guide".
Run EXPRESSBUILDER from Internal Flash Memory. For details, see Chapter 3 (4.
EXPRESSBUILDER).
Note
If bootable CD/DVD is inserted into optical disk drive, the system starts from
CD/DVD even if <F3> key is pressed.
Run Offline Tools. For information on Offline Tools, see Chapter 1 Maintenance (9. Offline
Tools) in "Maintenance Guide".
Tips
If One time or Always is specified for Power Management Policy in Server
menu of BIOS SETUP, a message indicating power consumption is being
measured is displayed instead of the message shown above. Wait for a while until
measurement is complete.
Express5800/R120g-2M User's Guide
1. Turning on the Server