Turning On The Server - NEC Express5800/R120g-2M User Manual

Chapter 3 Setup
1.

Turning on the Server

Pressing POWER Switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
1. Turn on a display, an Uninterruptible Power Supply (UPS), and other peripherals.
2. Remove Front Bezel.
3. If STATUS LED is lighting green or amber, wait until it goes off.
4. Press POWER Switch at the front of the server.
POWER LED is turned on green and after a while, logo appears on the display.
While logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware. For
details, see Chapter 3 (1.1 POST).
134
Tips
Wait for at least 30 seconds before turning on the server after turning it off.
Important Do not connect or disconnect USB device while POST is running.
POWER Switch
Express5800/R120g-2M User's Guide
1. Turning on the Server