Removal - NEC Express5800/R120g-2M User Manual

Chapter 2 Preparations
5. Connect the PCI riser card unit to the slot
on motherboard and secure the card with
the screw you removed in step 2.
Position the terminal part of the PCI riser
card to the slot on the motherboard and
insert it.
6. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
7. Make sure that no error messages are displayed on POST screen.
For details on POST error messages, see Chapter 3 (1. POST Error Message) in "Maintenance Guide".
8. Run the configuration utility of the card to set up the board as needed.
Availability or startup and operation procedure of the utility depends on card. For details, see the manual
that comes with the card. If a PCI card including RAID Controller, SAS controller, and LAN adapter
which connects to any bootable device is added, the boot priority might or changed to the default
setting. In that case, configure the boot priority in Boot menu of BIOS Setup Utility. For details, see
Chapter 2 (1. System BIOS) in "Maintenance Guide".
1.17.4

Removal

To remove a PCI card, reverse the installation procedure.
Run SETUP and change boot order in Boot menu as needed. See Chapter 2 (1. System BIOS) in "Maintenance
Guide" for how to specify it.
If using the server with the PCI card removed, attach the blank cover that comes with the riser card unit.
94
Tips
To connect a PCI card to the connector on motherboard with cable, connect a
cable to PCI card before installing PCI riser card unit.
Express5800/R120g-2M User's Guide
1. Installing Internal Optional Devices