Register To The Service Provider - Cisco WRP500 Administration Manual

Register to the Service Provider

R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
Register to the Service Provider
To use VoIP phone service, you must configure your WRP500 to the Internet Telephony Service Provider
(ITSP).
Note
Log in as administrator.
Step 1
Under the Voice menu, click Line 1 or Line 2 to choose the line interface that you want to modify.
Step 2
In the Proxy and Registration section, enter the Proxy.
Step 3
In the Subscriber Information section, enter the User ID and Password.
Step 4
Note
Click Submit. The devices reboot.
Step 5
To verify your progress, perform the following tasks:
Step 6
•
•
Cisco WRP500 Administration Guide
3-6
Each line tab must be configured separately. Each line tab can be configured for a different ITSP.
IMAGE WILL BE SUPPLIED (SCREENSHOT) - replaces 194553
These are the minimum settings for most ITSP connections. Enter the account information as
required by your ITSP.
Under the Voice menu, click Info. Scroll down to the Line 1 Status or Line 2 Status section of the
page, depending on which line you configured. Verify that the line is registered. Refer to the
following example.
IMAGE WILL BE SUPPLIED (SCREENSHOT) - replaces 194554
Use an external phone to place an inbound call to the telephone number that was assigned by your
ITSP. Assuming that you have left the default settings in place, the phone should ring and you can
pick up the phone to get two-way audio.
Chapter 3 Configure Voice Services