Setup > Mac Address Clone; Setup > Advanced Routing - Cisco WRP500 Administration Manual

Setup
R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
Backup MX
Wildcard
E-mail Address
TZO Key
Domain Name
Setup > MAC Address Clone
Enabled, Disabled
MAC Address
Setup > Advanced Routing
NAT
Dynamic Routing (RIP)
Cisco WRP500 Administration Guide
B-8
For DynDNS.org service, this feature allows the mail
exchange server to be a backup. To enable the feature,
select Enabled.
Default: Disabled
For DynDNS.org service, this setting enables or disables
wildcards for your host. For example, if your DDNS
address is myplace.dyndns.org and you enable wildcards,
then x.myplace.dyndns.org will work as well (x is the
wildcard). To enable wildcards, select Enabled.
Default: Disabled
For TZO.com service, the email address for your account.
For TZO.com service, the key for your account.
For TZO.com service, the domain name for your WRP500.
When this feature is enabled, you can assign a
previously registered MAC address to the WRP500 if
needed to meet the requirements of your service
provider.
The MAC address that you previously registered with
your service provider for this account.
If the WRP500 is hosting your network's connection to the
Internet, keep the default, Enabled. If another router exists
on your network, select Disabled. When the NAT setting is
disabled, dynamic routing will be enabled.
This feature enables the WRP500 to automatically adjust
to physical changes in the network's layout and to
exchange routing tables with the other router(s). The
WRP500 determines the route of the network packets
based on the fewest number of hops between the source
and the destination. When the NAT setting is enabled, the
Dynamic Routing feature is automatically disabled. When
the NAT setting is disabled, this feature is available.
Appendix B Data Fields