Line Status Section - Cisco WRP500 Administration Manual

Appendix A Advanced Voice Fields
R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
SIP Bytes Recv
External IP
Voice tab > Info page >

Line Status section

Hook State
Registration State
Last Registration At
Next Registration In
Message Waiting
Call Back Active
Last Called Number
Last Caller Number
Mapped SIP Port
Call 1 and 2 State
Call 1 and 2 Tone
Call 1 and 2 Encoder
Call 1 and 2 Decoder
Call 1 and 2 FAX
Total number of bytes of SIP messages received (including
retransmissions).
External IP address used for NAT mapping.
Hook state of the FXO port. Options are either On or Off.
Indicates if the line has registered with the SIP proxy.
Last date and time the line was registered.
Number of seconds before the next registration renewal.
Indicates whether you have new voice mail waiting. Options are
either Yes or No. The value automatically is set to Yes when a
message is received. You also can clear or set the flag manually.
Setting this value to Yes can activate stutter tone and VMWI signal.
This parameter is stored in long term memory and survives after
reboot or power cycle.
Indicates whether a call back request is in progress. Options are
either Yes or No.
The last number called from the FXO Line.
Number of the last caller.
Port number of the SIP port mapped by NAT.
May take one of the following values:
• Idle
• Collecting PSTN Pin
• Invalid PSTN PIN
• PSTN Caller Accepted
• Connected to PSTN
Type of tone used by the call.
Codec used for encoding.
Codec used for decoding.
Status of the fax pass-through mode.
Cisco WRP500 Administration Guide
Info page
A-3