Control Timer Values (Sec) Section - Cisco WRP500 Administration Manual

Appendix A Advanced Voice Fields
R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
Voice tab > Regional page >

Control Timer Values (sec) section

Hook Flash Timer
Min
Hook Flash Timer
Max
Callee On Hook Delay Phone must be on-hook for at this time in sec before the WRP500
Reorder Delay
Call Back Expires
Call Back Retry Intvl
Call Back Delay
VMWI Refresh Intvl
Interdigit Long Timer
Minimum on-hook time before off-hook qualifies as hook-flash.
Less than this the on-hook event is ignored. Range: 0.1–0.4
seconds.
The default is 0.1.
Maximum on-hook time before off-hook qualifies as hook-flash.
More than this the on-hook event is treated as on-hook (no
hook-flash event). Range: 0.4–1.6 seconds.
The default is 0.9.
will tear down the current inbound call. It does not apply to
outbound calls. Range: 0–255 seconds.
The default is 0.
Delay after far end hangs up before reorder tone is played. 0 = plays
immediately, inf = never plays. Range: 0–255 seconds.
The default is 5.
Expiration time in seconds of a call back activation. Range:
0–65535 seconds.
The default is 1800.
Call back retry interval in seconds. Range: 0–255 seconds.
The default is 30.
Delay after receiving the first SIP 18x response before declaring the
remote end is ringing. If a busy response is received during this
time, the WRP500 still considers the call as failed and keeps on
retrying.
The default is 0.5.
Interval between VMWI refresh to the CPE.
The default is 0.5.
Long timeout between entering digits when dialing. The interdigit
timer values are used as defaults when dialing. The
Interdigit_Long_Timer is used after any one digit, if all valid
matching sequences in the dial plan are incomplete as dialed.
Range: 0–64 seconds.
The default is 10.
Cisco WRP500 Administration Guide
Regional page
A-19