Cisco WRP500 Administration Manual page 69

Appendix A Advanced Voice Fields
R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
Feature Dial Services
Codes
These codes tell the WRP500 what to do when the user is listening
to the first or second dial tone.
One or more *code can be configured into this parameter, such as
*72, or *72|*74|*67|*82, etc. Max total length is 79 chars. This
parameter applies when the user has a dial tone (first or second dial
tone). Enter *code (and the following target number according to
current dial plan) entered at the dial tone triggers the WRP500 to
call the target number prepended by the *code. For example, after
user dials *72, the WRP500 plays a special tone called a Prompt
tone while awaiting the user to enter a valid target number. When a
complete number is entered, the WRP500 sends a INVITE to *72
target_number as in a normal call. This feature allows the proxy to
process features like call forward (*72) or BLock Caller ID (*67).
The *codes should not conflict with any of the other vertical service
codes internally processed by the WRP500. You can empty the
corresponding *code that you do not want to the WRP500 to
process.
You can add a parameter to each *code in Features Dial Services
Codes to indicate what tone to play after the *code is entered, such
as *72'c'|*67'p'. Below are a list of allowed tone parameters (note
the use of back quotes surrounding the parameter w/o spaces)
'c' = <Cfwd Dial Tone>
'd' = <Dial Tone>
'm' = <MWI Dial Tone>
'o' = <Outside Dial Tone>
'p' = <Prompt Dial Tone>
's' = <Second Dial Tone>
'x' = No tones are place, x is any digit not used above
If no tone parameter is specified, the WRP500 plays Prompt tone by
default.
If the *code is not to be followed by a phone number, such as *73 to
cancel call forwarding, do not include it in this parameter. In that
case, simple add that *code in the dial plan and the WRP500 send
INVITE *73@..... as usual when user dials *73.
Cisco WRP500 Administration Guide
Regional page
A-25