Speed Dial Settings Section; Supplementary Service Settings Section - Cisco WRP500 Administration Manual

Appendix A Advanced Voice Fields
R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
Accept Last Caller
Cfwd Last Caller
Cfwd Last Dest
Voice tab > User page >

Speed Dial Settings section

This section does not apply to the WIP310 wireless phone.
Speed Dial 2-9
Voice tab > User page >

Supplementary Service Settings section

The WRP500 provides native support of a large set of enhanced or supplementary services. All of
these services are optional. The parameters listed in the following table are used to enable or
disable a specific supplementary service. A supplementary service should be disabled if a) the user
has not subscribed for it, or b) the Service Provider intends to support similar service using other
means than relying on the WRP500.
CW Setting
Block CID Setting
Block ANC Setting
ID of caller accepted via the Accept Last Caller service.
The default is blank.
The Caller number that is actively forwarded to Cfwd Last Dest by
using the Call Forward Last activation code
The default is blank.
Forward number for the Cfwd Last Caller parameter.
Same as Cfwd All Dest.
The default is blank.
Target phone number (or URL) assigned to speed dial 2, 3, 4, 5, 6,
7, 8, or 9.
The default is blank.
Call Waiting on/off for all calls.
The default is yes.
Block Caller ID on/off for all calls.
The default is no.
Block Anonymous Calls on or off.
The default is no.
Cisco WRP500 Administration Guide
User page
A-43