Audio Configuration Section - Cisco WRP500 Administration Manual

Appendix A Advanced Voice Fields
R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
VMWI Serv
Speed Dial Serv
Secure Call Serv
Referral Serv
Feature Dial Serv
Service Announcement
Serv
Voice tab > Line page >

Audio Configuration section

A codec resource is considered as allocated if it has been included in the SDP codec list of an
active call, even though it eventually may not be the one chosen for the connection. So, if the
G.729a codec is enabled and included in the codec list, that resource is tied up until the end of the
call whether or not the call actually uses G.729a. If the G.729a resource is already allocated and
since only one G.729a resource is allowed per device, no other low-bit-rate codec may be allocated
for subsequent calls; the only choices are G711a and G711u. On the other hand, two G.723.1/G.726
resources are available per device.
Therefore it is important to disable the use of G.729a in order to guarantee the support of two
simultaneous G.723/G.726 codec.
Enable VMWI Service (FSK).
The default is yes.
Enable Speed Dial Service.
The default is yes.
Enable Secure Call Service.
The default is yes.
Enable Referral Service. See the Referral Services Codes parameter
for more details.
The default is yes.
Enable Feature Dial Service. See the Feature Dial Services Codes
parameter for more details.
The default is yes.
Enable Service Announcement Service.
The default is yes.
Cisco WRP500 Administration Guide
Line page
A-39