Line Enable Section; Streaming Audio Server (Sas) Section - Cisco WRP500 Administration Manual

Appendix A Advanced Voice Fields
R E V I E W D R A F T # 1 — C I S C O C O N F I D E N T I A L
•
•
•
•
•
•
•
•
In a configuration profile, the Line parameters must be appended with the appropriate numeral (for
example, [1] or [2]) to identify the line to which the setting applies.
Voice tab > Line page >

Line Enable section

Line Enable
Voice tab > Line page >

Streaming Audio Server (SAS) section

SAS Enable
SAS DLG Refresh Intvl
"SIP Settings section" section on page A-32
"Call Feature Settings section" section on page A-34
"Proxy and Registration section" section on page A-34
"Subscriber Information section" section on page A-36
"Supplementary Service Subscription section" section on page A-37
"Audio Configuration section" section on page A-39
"Dial Plan section" section on page A-40
"FXS Port Polarity Configuration section" section on page A-41
To enable this line for service, select yes. Otherwise, select no.
The default is yes.
To enable the use of the line as a streaming audio source, select yes.
Otherwise, select no. If enabled, the line cannot be used for
outgoing calls. Instead, it auto-answers incoming calls and streams
audio RTP packets to the caller.
The default is no.
If this value is not zero, it is the interval at which the streaming
audio server sends out session refresh (SIP re-INVITE) messages to
determine whether the connection to the caller is still active. If the
caller does not respond to the refresh message, the WRP500 ends
this call with a SIP BYE message. The range is 0 to 255 seconds (0
means that the session refresh is disabled).
The default is 30.
Cisco WRP500 Administration Guide
Line page
A-29