Table of Contents
Advertisement
CA Series PC/104
Hardware Installation
Installing the CA/CB Series module is easy. For the CA Series, before inserting the module into the PC/104 slot,
you must first configure the I/O base address, interrupt vector, IRQ, and serial interface (for select models).
ATTENTION
Safety First!
To prevent damage to your system or board, make sure your embedded PC's power is turned off before
installing your CA/CB Series module.
CA Series
Step 1:
Shut off power to your embedded PC and
to any peripheral devices. After shutting
off power, remove the cover of your
embedded PC.
Step 2:
Use the DIP switches on the module to
select the I/O base address, interrupt
vector, IRQ, and serial interface (for
select models). Details for each model
are provided later in this chapter.
Step 3:
Insert the module firmly into the
embedded PC's PC/104 slot.
Step 4:
Screw the control board in place
Step 5:
Connect the cables.
Step 6:
Power on the embedded PC.
Block Diagrams
CA-108
CB Series
Step 1:
Shut off power to your embedded PC
and to any peripheral devices. After
shutting off power, remove the cover
of your embedded PC.
Step 2:
Use the DIP switches on the module
to select the serial interface. Details
for each model are provided later in
this chapter.
Step 3:
Insert the module firmly into the
embedded PC's PC/104-Plus slot.
Step 4:
Screw the control board in place.
Step 5:
Connect the cables.
Step 6:
Power on the embedded PC. The
BIOS will automatically set the IRQ
and I/O address.
Step 7:
Proceed with the software
installation. Please refer to Chapter 3.
2-2
Hardware Installation
Advertisement
Table of Contents
