Table of Contents
Advertisement
CA Series PC/104
Software Installation
5. After the files have been installed, a configuration panel will open. This is where boards are installed,
configured, and removed. If another board has already been installed on the system, it will already be listed.
Windows NT does not automatically detect Moxa UPCI boards, so you will need to click Add for a newly installed
board.
6. Under Board Type, select the UPCI board that is being installed. The window will show the COM settings for
the serial ports on the board. You can modify the COM settings for any port at this time by selecting a port and
clicking Port Setting. If you are satisfied with the COM settings, click OK to return to the configuration panel.
3-24
Advertisement
Table of Contents
