Table of Contents
Advertisement
CA Series PC/104
Software Installation
Windows NT
Installing the Driver
You will need to plug the board in an available PCI or PCI-X slot first, before installing the driver.
Note that these instructions use the CB-114 as an example. The procedure for installing all models is the same.
1. Log into Windows NT as Administrator.
2. Locate the appropriate folder for your board's drivers on the Document & Software CD. The NT drivers will
be located under the product folder in the \Software\WinNT directory (e.g., under \CB-114 Series\Software).
Copy this folder to the PC's hard disk and remember its location.
3. In the Control Panel, open Network applet. On the Adapters tab, click Add. When prompted to select a
product, click Have Disk....
You will be prompted to enter the path to the driver. Enter the location of the drivers that you copied from the
Document & Software CD (C:\Windows.nt in this example) and then click OK.
4. When prompted, select your board model (Smartio/Industio Family multiport board in this example)
and click OK.
3-23
Advertisement
Table of Contents
