Table of Contents
Advertisement
CA Series PC/104
be allowed to use one multiport serial board on the target host.
6. After adding Moxa Tech drivers into your OS Design, a new project is automatically added to your workspace.
The project name is mxpcdrvce5.reg. The project can be accessed from View File View. The
mxpcdrvce5.reg project contains a number of files used to configure the drivers included in your OS Design. For
ISA boards, remember to set the IRQ and I/O address in mxpcdrvce5.reg. For example, if your IRQ is 10,
IOBASE is 0180, Interrupt and Vector is 01c0, then you should configure "1A" for SysIntr, "0180" and "01c0"
for IOBASE, "A" for IRQ ,and "1" for FIFO. When applying the formula "IRQ+10", remember that IRQ is in base
10, and 10 is in Hex format. If we first convert the IRQ value to Hex format, then SysIntr will equal 1A.
Otherwise, set FIFO to 1 to enable the FIFO.
NOTE
To use the "Terminal Emulator" tool, modify mxpcdrvce5.reg and keyboard as shown below (this is just for
"one" "COM" port). Take note of the number of ports, COM, and MXU, and then enter the correct information.
[HKEY_LOCAL_MACHINE\ExtModems\HayesCompat1]
"Port"="COM2:"
"DeviceType"=dword:1
"FriendlyName"="Hayes Compatible on COM2:"
3-18
Software Installation
Advertisement
Table of Contents
