Table of Contents
Advertisement
CA Series PC/104
Software Installation
5. Press F10 to save the latest configuration and exit the setup program.
Loading the Driver
After setting up the driver, you must load the driver in order to gain access to the serial ports on the module.
Run BIN\DPC-DRV.EXE at the DOS prompt. The driver will detect your CB Series module automatically. You
should see messages indicating successful detection of your module, such as the following:
Smartio/Industio Family DOS driver Version 1.8
Setup driver ...
CB-114 series (Bus=x, Dev=y): OK!
Device driver setup O.K.
At this point, you can execute applications that support API-232 functions, or start developing applications
using the API-232 library.
Unloading the Driver
To unload or release the CB Series driver from memory, enter DPC-DRV/Q at the DOS prompt.
3-22
Advertisement
Table of Contents
