Table of Contents
Advertisement
CA Series PC/104
Software Installation
7. The board will now appear in the configuration panel (CB-114 Series in this example). Click OK to return
to the Network applet. After that, click OK again to exit the Network applet
8. Restart the PC. After you have logged back into Windows NT, you may check the event log issued by the
Moxa driver to see if the board's ports have been initialized successfully. In the Administrative group, open
Event Viewer and select Log and System. For each newly installed or configured Moxa UPCI board, check for
a message stating that the board has been enabled (e.g., "MoxaCB-114 board, with first serial port COM3, has
been enabled").
Configuring the Ports
1. In Windows Control Panel, open the Network applet. In the Adapters tab, UPCI boards will appear as a
type of Moxa adapter (MOXA Smartio/Industio Family Adapter in this example). Select the Moxa adapter
and click Properties....
3-25
Advertisement
Table of Contents
