Inserting Scanner Glass - Contex HD Ultra X 6000 Series User Manual

Maintenance

Inserting scanner glass

Replacing the scanner glass
43
Insert new scanner glass

Check that the flat magnetic surfaces inside the scanner are
clean and free from dirt or dust. Use a small vacuum device
if necessary.

Carefully bring the new scanner glass near to the open scan
area

TAKE CARE NOT TO ACCIDENTALLY BRUSH DIRT OR
CONTAMINANTS INTO THE SCANNER

Using both hands support the glass by the fingertips then
carefully lower it into position taking care to locate each end
plate (up-side of glass) onto its four corresponding location
points inside the scanner body

The magnetic strips on the underside of the glass serve to
maintain the position of the glass once located. Use the
fingertips to confirm the glass is properly seated.
NOTE: You may need to clean both sides of the scan glass
if it has become marked during handling.
Recalibration is recommended after changing the scanner glass
1
2
3
53