Contex HD Ultra X 6000 Series User Manual page 16

Installation
Power ON the scanner
10
Turn ON scanner power
Turn on the main power switch at the back of the scanner.
Connect Cables
11
Connect the USB interface cable to the scanner
Initial installation and activation of the scanner is easiest using the USB connection.
1. The interface connections are at the back of the scanner on the left side. The USB socket on the
scanner is colored blue inside.
2. Connect the squarer, step-shaped (B-connector) end of the cable to the USB socket.
NOTE: The installation wizard will guide you through installation and activation of the Gigabit
network interface later in the installation process. Do not connect it yet.
Regulatory Notice: This scanner has been tested to comply with the EMC Standards EN55022
and FCC Part 15. To maintain compliance use only the interface cables supplied with the scanner.
15