Lowering Otac; Resetting Otac To Thin Media Position (Use Hands) - Contex HD Ultra X 6000 Series User Manual

Thick media
Thick Media (OTAC)

Lowering OTAC

From the fully raised position (previous section), OTAC needs to be lowered
down on to the thick media before scanning can be started.
Lowering OTAC for thick media (top lid button)

Pull the uppermost of the two buttons on the back of the scanner lid
nearest the keypad inwards, and then release it. This moves the OTAC
down in steps of 1-2mm. Continue pressing the button in and releasing
it until it no longer clicks. OTAC will determine the correct pressure
required for the thick media automatically.
Scan input size

Set the input size dimension in the software large enough to accept the
area of the thick original required

After scanning completes remove or eject the thick document manually
using the Forward button.
Resetting OTAC to thin media position (use palms of
hands)

Using the palms of both hands push down gently on the ends of the lid
until the lid stops moving, then let go.

Now grip the top button with the fingertips from the front of the scanner
and pull it towards you 1-2 more times. This will fully lock OTAC into
the paper position. The yellow 'OTAC raised' indicator light will now
turn off.
Yellow led light stays on when
OTAC is in raised position
PULL in then release the top button to
lower OTAC in steps (1-2mm)
36
PULL